Want to run C2000 Delta with Ethercat card

Hello @snujcnc,

Have TWINCAT3 to configure and test it to work??

Do you have a manual??

You have linuxcnc-ethercat installed??

you can scan the device with the command to get that the PDO starts with the device, then it would try to create the ethercat .xml configuration file with the generic mode

Greeting
Chimeno

Hello Chimeno, I want to know if you can help me to configure the generic XML file for Delta C2000 plus VFD with ethercat card CMC-EC01?
I can see the drive with ethercat slaves, but when I run the ethercat slaves pdos, the slave does not appear. Thanks in advance

Hello: did you had success with the control of C2000 VFD with ethercat card CMM-EC01?

forum.linuxcnc.org/38-general-linuxcnc-q...ronous-position-mode