I thought so, just had to be sure.
Thank you.
I did try to find the pin in axis, but there is no search function. Maybe doing a pin dump from terminal and then using text editor to search could yield results ?
linuxcnc has no internally tracked jog rate - each GUI has it's own.
If the GUI gives no access to it's internals then you are out of luck.
assuming you want to be able to use the GUI's controls.
It's probably possible with AXIS, but you'll need to figure out how - there is not much for documentation.
Gmoccapy -I don't think it gives access at all.
Asking in one thread would have been fine (ie I'm not going to answer the other thread)
In terminal, while Linuxcnc is running:
halcmd -kf | tee pin.txt
then
show pin
It creates the pin.txt file in your home directory with all the pins available, so you can search with a text editor.
