- Posts: 8
- Thank you received: 0
HAL for Pokey57
- charlieLedezma
- Topic Author
- Offline
- New Member
-
5 years 4 months ago #211494
by charlieLedezma
HAL for Pokey57 was created by charlieLedezma
Hi Everyone
Last year wrote asking for help to configure a Pokey Motion Controller, but sadly I didn´t get answer. This time, I wish than one kind soul (
) can share a .hal configuration with me. I am getting run the pokey properly, but my knowledge in Linuxcnc is pretty poor. Please help me and sorry with my English
Last year wrote asking for help to configure a Pokey Motion Controller, but sadly I didn´t get answer. This time, I wish than one kind soul (
) can share a .hal configuration with me. I am getting run the pokey properly, but my knowledge in Linuxcnc is pretty poor. Please help me and sorry with my English Please Log in to join the conversation.
- tommylight
-
- Away
- Administrator
-
Time to create page: 0.134 seconds