Two inputs 7i76 to one output

I added to my hall abort.halui and conected them to stop button and input 05 on 7i76 and this working
But now need add other button to the same abort.halui on input 11 on 7i76
 

Using OR logic component included with LinuxCNC should do that, adding it in the hal file.
linuxcnc.org/docs/html/man/man9/or2.9.html

This will work?

loadrt stop count=2

net przycisk-stop or2.0.in0 <= hm2_7i92.0.7i76.0.0.input-05

net konik-stop or2.0.in1 <= hm2_7i92.0.7i76.0.0.input-11-not

net stop <= or2.0.out

Needs to be "loadrt or2"

For now I have ready e-stop latch 3 inputs and in hal exist loadrt or2 count=1
With other loadrt or2 I get error
Is posibble using or2 for two or more different inputs?

you have to put loadrt and addf to load it correctly.

loadrt or2 count=1
addf or2.0 servo-thread

net przycisk-stop or2.0.in0 <= hm2_7i92.0.7i76.0.0.input-05

net konik-stop or2.0.in1 <= hm2_7i92.0.7i76.0.0.input-11-not

net stop <= or2.0.out

If you are using estop-latch, and you just want to respond to an estop, you dont need and2 as estop latch does it all by building an estop chain.

I think anybady watch the hal file..
For now in the hal I have ready and working;
-estop chain
-pause/resume button and this use or2
When write in hal
net przycisk-stop or2.0.in0 <= hm2_7i92.0.7i76.0.0.input-05
net konik-stop or2.0.in1 <= hm2_7i92.0.7i76.0.0.input-11-not
net stop <= or2.0.out
Get error or2.0.in0 Exist
Try to change in0 and in1 to in2 and in3 but dont luckly.

have this for my Probe_input

For the next one looking how to make or2 working.
Yes is possible make many or2
my setting now is;

loadrt or2  names=or.2.1,or2.2,or2.3       Must delete count=1  becouse linuxcnc start with error
addf or2.0 servo-thread
net przycisk-stop or2.3.in0 <= hm2_7i92.0.7i76.0.0.input-05-not  
net konik-stop or2.3.in1 <= hm2_7i92.0.7i76.0.0.input-11-not
net stop <= or2.3.out

Other problem was the input 05 is NC and connected to halui.abort without -not working ok.
But with or2 I must to change it and add -not