radius/diameter programming and hal

I'm not an expert with deb installs but I think it would be './bin/gmoccapy'.
Not sure you even get the .py file with a deb install but the file found in /bin should be the same.


Forget the output with '/run/user/1000/gvfs' that is a mount point where gnome accesses samba shared files and such things.

so... if I understand... might not have the .py extension but is still the operating file.
Will look.
Thank you.

Finally could get back to things.
Found it in: ./bin
It did lose it's .py
and NOTHING in the ./bin directory shows up on a find. In the desktop browse or in a sudo find.
I'm beginning to believe linux likes distressing us dos boys.
Thanx all

Wish I could make the logic changes update proof.