spindle.0.on already link to spindle-enable

More
2 years 5 months ago #301250 by greg23_78
spindle.0.on already link to spindle-enable was created by greg23_78
I have a problem to linking my pin spindle.0.on to another signal.
the error message is " spindle.0.on already link to spindle-enable "

my code
Code:
# ---SPINDLE--- net spindle-enable             <=  spindle.0.on net spindle-enable => gearchange.0.spindle-on => hm2_5i25.0.7i77.0.1.spinena # ---LUBE--- net machine-is-enabled  <= motion.motion-enabled net machine-is-enabled  => and2.0.in0 net spindle-running  <= spindle.0.on net spindle-running  => and2.0.in1 net lube-run <= and2.0.out net lube-run => hm2_5i25.0.7i77.0.0.output-00 net lube-ps-float-sw  <= hm2_5i25.0.7i77.0.0.input-09 net lube-ps-float-sw => oillow.trigger

How can i connect spindle.0.on to my lube output ?

Please Log in to join the conversation.

More
2 years 5 months ago #301254 by PCW
Replied by PCW on topic spindle.0.on already link to spindle-enable
replace

net spindle-running  <= spindle.0.on
net spindle-running  => and2.0.in1

with

net spindle-enable  => and2.0.in1

Please Log in to join the conversation.

More
2 years 5 months ago #301261 by greg23_78
Replied by greg23_78 on topic spindle.0.on already link to spindle-enable
thank you, it works perfectly.
But what's wrong with my programming?
Because I have the same problem with the message.comp
Code:
net lube-ps-float-sw  <= hm2_5i25.0.7i77.0.0.input-09 net lube-ps-float-sw => oillow.trigger
"hm2_5i25.0.7i77.0.0.input-09 is already link to lube-ps-float-sw"

Please Log in to join the conversation.

More
2 years 5 months ago #301263 by PCW
Replied by PCW on topic spindle.0.on already link to spindle-enable
What you show is OK:net lube-ps-float-sw  <= hm2_5i25.0.7i77.0.0.input-09
net lube-ps-float-sw => oillow.trigger
There must be another connection to hm2_5i25.0.7i77.0.0.input-09
elsewhere in a hal file
 

Please Log in to join the conversation.

Time to create page: 0.468 seconds
Powered by Kunena Forum