Using a HAL pin in DH parameters

More
2 years 1 month ago #309657 by Abdulkareem
Using a HAL pin in DH parameters was created by Abdulkareem
I want to set A0 parameter as an input from the user interface, so i added this hal pin, but linuxcnc gives this error message

Attachment not found

Attachment not found

Attachment not found

Please Log in to join the conversation.

More
2 years 1 month ago #309658 by Aciera
Replied by Aciera on topic Using a HAL pin in DH parameters
Not sure if 'genserkins.A-0' is a pin or a parameter but try using 'net' instead of 'setp'

Please Log in to join the conversation.

More
2 years 1 month ago #309660 by Abdulkareem
Replied by Abdulkareem on topic Using a HAL pin in DH parameters
tried it but it gives this error  

Attachment not found

Please Log in to join the conversation.

More
2 years 1 month ago #309662 by Aciera
Replied by Aciera on topic Using a HAL pin in DH parameters
The pyvcp panel only exists after the gui has loaded, so you will need to put that line in the POSTGUI_HALFILE

Please Log in to join the conversation.

More
2 years 1 month ago #309713 by Abdulkareem
Replied by Abdulkareem on topic Using a HAL pin in DH parameters
tried that, but still getting the same error

Please Log in to join the conversation.

More
2 years 1 month ago #309716 by meister
Replied by meister on topic Using a HAL pin in DH parameters
how do you create the 'x-rot-point' widget ?
can you see the pin in halshow ?
have this widget an ...-f output ?

Please Log in to join the conversation.

More
2 years 1 month ago #309719 by Abdulkareem
Replied by Abdulkareem on topic Using a HAL pin in DH parameters
 

Attachment not found

 

Attachment not found


i have added it to the postgui hal file, i just have to give it a name, thank you it works fine 

Please Log in to join the conversation.

Time to create page: 0.090 seconds
Powered by Kunena Forum