Classicladder not saved

Hi,

Today I've started my first experiment with Classicladder.
I've added the input and output signals to the HAL file
I can see that the input signal from the 7i77 is shown in the "Bit Status" of Classicladder
I also can activate the outputs on the 7i77 by selecting the checkbox in the "Bit Status".
But when I write a simple program, it does not work.
I've seen that when I save the program, en reopen it again... it is empty.

what am I doing wrong?

Peter

If I add a section, this is saved when I reopen Classicladder.
But the rest is gone...

Ok, I found the problem...
You first have to click OK before saving

I'm guessing you did not click on Ok in the Editor window before saving.

JT

Hi BigJohnT

This was indeed the problem.
Tx!!!

I think we posted within a second of each other.

JT