LinuxCNC not loading classicladder on startup

I've written and tested a short ladder program using linuxCNC then saved it to the config folder. I added the loadrt and addf lines to my custom.hal file, along with the loadusr line that is supposed to start running the program. When I start linuxcnc and check classicladder, it says it was unable to load the program, but when I try to manually load it, it has no issues and everything runs fine. Is there something else that I am supposed to add for it automatically start running the program? I'm running 2.8 with gmoccapy.

can you post the relevant files?

You are telling it to not load the GUI. You realize that? So if your expecting to see the interface, it wont show up with --nogui

I know the window wasn't supposed to show up, but it would not run the program. I tried later without the --nogui and it did the same thing, nothing at all. I ended up moving the loadusr command into the custom post gui hal file while leaving the loadrt and addf commands in the normal custom.hal, it solved the issue.

ExcessiveO wrote:

I know the window wasn't supposed to show up, but it would not run the program. I tried later without the --nogui and it did the same thing, nothing at all. I ended up moving the loadusr command into the custom post gui hal file while leaving the loadrt and addf commands in the normal custom.hal, it solved the issue.G

Glad its working. That is weird./ I have the loadrt and loadusr in the same file. One right after and it works fine. Maybe it is a gmoccapy  thing. I use axis.