（resolved）The "classicladder numPhysInputs" parameter does not take effect.

Hello everyone, when I was configuring the calssicladder, the number of corresponding physical inputs was always limited to no more than 16 points.

debug:
linuxcnc TPMOD=tpmod HOMEMOD=homemod EMCMOT=motmod
Note: Using POSIX realtime
Found file(REL): ./L510G_servo.hal
*** hal/components/xyzab_tdr_kins.comp setup ok
Found file(REL): ./calssicladder.hal
creating ladder-state
./calssicladder.hal:87: Pin 'lcec.1.input.in1-16' does not exist
Shutting down and cleaning up LinuxCNC...


Due to my negligence, the bed used an unknown PIN-16... This was not caused by a software issue.

Redefine outputs from 20 to 32, or whatever you need.

loadrt classicladder_rt numRungs=12 numBits=100 numWords=10 numTimers=10 numMonostables=10 numCounters=10 numPhysInputs=20 numPhysOutputs=32 numArithmExpr=100 numSections=4 numSymbols=300 numS32in=5 numS32out=5

linuxcnc.org/docs/devel/html/man/man9/classicladder.9.html

Look at this