open loop servo tuning.

More
7 years 5 months ago #133132 by andypugh
Replied by andypugh on topic open loop servo tuning.
Can you attach the actual INI file?

Stepgen limits normally belong in the Axis section. Though the HAL file can, in theory, look anywhere.

And nothing will jog faster than [TRAJ]MAX_VELOCITY

linuxcnc.org/docs/2.7/html/config/ini-config.html#_traj_section

Please Log in to join the conversation.

More
7 years 5 months ago #133133 by skvallab
Replied by skvallab on topic open loop servo tuning.
attaching my ini file

Attachment not found

Attachment not found

Attachment not found

Attachment not found

Attachment not found

Attachment not found

Please Log in to join the conversation.

More
7 years 5 months ago #133149 by andypugh
Replied by andypugh on topic open loop servo tuning.
You can remove the STEPGEN_MAX_xxx stuff from [TRAJ] as it isn't used with a PPMC config, and the entries don't belong there anyway.
Increasing the PID_MAX_VEL was the way to go.

I suspect that the problem is the [TRAJ]MAX_VELOCITY

You might also try adding a [DISPLAY]MAX_ANGULAR_VELOCITY as the problem might just be that the GUI doesn't let you turn the angular jog rate up that far.

Please Log in to join the conversation.

More
7 years 5 months ago #133325 by skvallab
Replied by skvallab on topic open loop servo tuning.
[TRAJ]
i dont have anything listed as traj.
but i have a motor mounted on the linear actuator , but their values are not inter related.
should add both the motors in TRAJ section?

Please Log in to join the conversation.

More
7 years 5 months ago #133349 by Todd Zuercher
Replied by Todd Zuercher on topic open loop servo tuning.

skvallab wrote: [TRAJ]
i dont have anything listed as traj.
but i have a motor mounted on the linear actuator , but their values are not inter related.
should add both the motors in TRAJ section?


Yes you do, in your ini file posted above, this section is what Andy is refering to.
Code:
# Trajectory planner section -------------------------------------------------- [TRAJ] AXES = 3 # COORDINATES = X Y Z COORDINATES = X Y Z HOME = 0 0 0 LINEAR_UNITS = mm ANGULAR_UNITS = degree CYCLE_TIME = 0.010 DEFAULT_VELOCITY = 0.167 MAX_VELOCITY = 100 DEFAULT_ACCELERATION = 300.0 MAX_ACCELERATION = 500.0 STEPGEN_MAXACCEL = 750.0

Please Log in to join the conversation.

Time to create page: 0.116 seconds
Powered by Kunena Forum