old cnc lathe retrofit

yes it is awaysome good condition
so keep all parts just rewirer to a better and understandable Control like 7i77
you can go with a 7i92 to a ethernetcnc controlled mashine

BUT first if you can move the mashine by Auto or manuell mode check if the drives are analog 0-10V at that time
or newly +-10V as the 7i77 is sopost to run

It is not my machine in the photos it is a same model machine.
Mine is in used condition not like new as this in the photos.
But i found way how to regrind ways or use linear rails if needed.