Standard-modern 1700 series retrofit

You are striping and wiring wires above them, those have lots of holes, a single very small piece of wire falling down can mess something up.
Cover them.
That is not a request, it is an order!

Had some time to make a bit of progress on the pendant. 

  downsizing the portion that held the CRT. 

  got the front panel from laser and bent up the tray.

  The pc motherboard on the new swinging access door , still have to extend the wiring for the power supply.

  where I left off for the night , just had the monitor running off my phone for a test , managed to lose a nut from one of my rotary switches.

Atx extensions and my ssd arrived , got rodw's Debian 12 / linuxcnc 2.9 installed , can start learning the ins and outs of that while I wait on mesa cards. 

Special delivery in the mail today , I went with a 7i95t 7i83 for the analog and a 7i84 for my front panel. Got them all mounted and wired in , realized I have to update 2.9 to support the 7i95t.,  but of coarse I'm out of time today.

 

managed to go out to the garage after work and after some time zone issues i got 2.9 updated , i used mesact to make a super simple config to start with , but now im getting a watchdog error , error report attached . does this have anything to do with the wiring of my smart serial cards ?
hm2_7i95t.0.watchdog.timeout_ns' not found
 

Mesact will do a successful board check at ip 10.10.10.10I can not ping 10.10.10.10 it gives me the error pictured below If I use the pictured command in mesa flash it gives a no ethernet board found.Ethernet setup was done following the guide on here. 
 

Watchdog error had to do with mesact needing a update.

Lots of Headway made , encoders scaled and drives tuned as best I can tune them for now , have some nice smooth motion happening. And full travel with no following error, still not a flat line in halshow but I can work on that.

Having trouble getting my spindle encoder to show rpm in gmocappy thats this evenings project.




www.youtube.com/shorts/kDQqG9uol94?app=desktop
 

Got the spindle encoder issue sorted so I have rpm display , also found out that the encoder scale needed to be negative as my a/b must be reversed , now have spindle synchronized motion working , time to put the guards back on and start some test cuts.

Ignore the backwards x move , I have been working on my lathe post and flipped my x around along the way.

For the first time in 15+ years the standard modern 1700 is cutting metal , got the tool changer sorted out and did some test cuts in plastic before making up a jt1 Arbour.

Hige shout out to the people around here for all their knowledge.

Have to sort out my g2/g3 ijk in my cam post but we're on our way.