OLD Lathe conversion to a CNC

More
2 years 2 months ago #307575 by besriworld
Replied by besriworld on topic OLD Lathe conversion to a CNC
Thanks, what size should the ring be?

Please Log in to join the conversation.

More
2 years 2 months ago #307603 by tommylight
Replied by tommylight on topic OLD Lathe conversion to a CNC
Whatever size you can put the cable through and do at least 1 or 2 windings.

Please Log in to join the conversation.

More
2 years 2 months ago #307711 by besriworld
Replied by besriworld on topic OLD Lathe conversion to a CNC
I have a 7i73 for the control panel. Interesting when it lost communication with the board 7i98. Always the output pins remain at the levels they were before it lost connection with the host.. Is this normal? Or there is a specific setting in Hal .
It's not critical, but I think it's not normal.

Please Log in to join the conversation.

More
2 years 2 months ago #307715 by tommylight
Replied by tommylight on topic OLD Lathe conversion to a CNC
You should ask that in the "driver boards" section of the forum as i am not sure PCW monitors this side of the forum, well i am sure he does sometimes, but not sure if always.

Please Log in to join the conversation.

More
2 years 2 months ago #307718 by PCW
Replied by PCW on topic OLD Lathe conversion to a CNC
Since the 7I73 was designed for control panels and not direct machine control
it does not automatically disable outputs on a fault. I suppose that feature could
be added but it might make more sense to use a 7I84/7I84U in that case.

Please Log in to join the conversation.

More
2 years 2 months ago #307720 by besriworld
Replied by besriworld on topic OLD Lathe conversion to a CNC
Thank you! Yes, I also use it as a control panel.
OK, no problem!

Please Log in to join the conversation.

More
2 years 2 months ago #308429 by besriworld
Replied by besriworld on topic OLD Lathe conversion to a CNC
I'm making chips again :) . It was difficult to deal with the removal of the chips.

Aluminum is 6082 t6


Please Log in to join the conversation.

More
2 years 1 month ago #310327 by besriworld
Replied by besriworld on topic OLD Lathe conversion to a CNC
A little update:) ... it works as a horizontal miling machines  :d

 

Attachment not found

Attachment not found

Attachment not found

Please Log in to join the conversation.

More
2 years 1 month ago #310330 by tommylight
Replied by tommylight on topic OLD Lathe conversion to a CNC
Fixed the tittle.

Please Log in to join the conversation.

More
2 years 4 weeks ago #311126 by besriworld
Replied by besriworld on topic OLD Lathe conversion to a CNC
I can now use more than one tool... I made some parts from 6082 aluminum, but I can't get the chips to break; they always tangle.Does anyone have any experience witch 6082?

 

Attachment not found

Attachment not found

Attachment not found

Attachment not found

Please Log in to join the conversation.

Time to create page: 0.254 seconds
Powered by Kunena Forum