Separate encoder or encoder output from servo driver.

More
1 year 5 months ago #327529 by Jdolecki
Separate encoder or encoder output from servo driver. was created by Jdolecki
Originally my lathe had an encoder attached to the spindle head. 

My new spindle motor servo driver has an encoder output. Servo is geared 1to1 with the spindle. 

I’m assuming that will be enough fore position control.

I using a 7i96 board.
 

Please Log in to join the conversation.

More
1 year 5 months ago #327531 by andypugh
Replied by andypugh on topic Separate encoder or encoder output from servo driver.
Yes, that should work fine.

Please Log in to join the conversation.

Time to create page: 0.080 seconds
Powered by Kunena Forum