RT-8p8c - An ethernet based interface for LinuxCNC

More
13 years 11 months ago #26880 by bigalex
Replied by bigalex on topic Re:RT-8p8c - An ethernet based interface for LinuxCNC
Hello Guys !
Is the firmware for the HostMot2 7i80 module inside LinuxCNC available ?
If yes , is it possible to configure the machine (using 7i80 architecture) with PnCConf ?

Thanks :blink:

Please Log in to join the conversation.

More
13 years 11 months ago #26881 by andypugh
Replied by andypugh on topic Re:RT-8p8c - An ethernet based interface for LinuxCNC
The 7i80 driver is being worked on (not by me) but is proving troublesome.

Please Log in to join the conversation.

More
11 years 4 months ago #60018 by jtc
Replied by jtc on topic RT-8p8c - An ethernet based interface for LinuxCNC
Hi.

What is the current status of this project?

João

Please Log in to join the conversation.

More
11 years 4 months ago #60019 by PCW
Replied by PCW on topic RT-8p8c - An ethernet based interface for LinuxCNC
If you are asking about RT-8p8c I'm not sure what the status is (maybe kinsa can answer)

The 7I80 and similar cards (7I76e, 7I92, 7I93) are supported by the userspace version of
Linuxcnc 2.7 or greater running under Preempt-RT

Please Log in to join the conversation.

More
11 years 4 months ago #60024 by jtc
Replied by jtc on topic RT-8p8c - An ethernet based interface for LinuxCNC
Yes, the RT-8p8c.

Please Log in to join the conversation.

More
11 years 4 months ago #60025 by kinsa
Replied by kinsa on topic RT-8p8c - An ethernet based interface for LinuxCNC
Hi,

The development for this board has stopped as I moved on to RPi and similar boards.

The 7I92 from mesa is I think the best alternative to this board.

Cheers

Please Log in to join the conversation.

More
11 years 4 months ago #60033 by jtc
Replied by jtc on topic RT-8p8c - An ethernet based interface for LinuxCNC
I send you a PM.


João

Please Log in to join the conversation.

More
11 years 4 months ago #60049 by kinsa
Replied by kinsa on topic RT-8p8c - An ethernet based interface for LinuxCNC

jtc wrote: I send you a PM.


João

Sorry, I don't think my PM box is enabled

Please Log in to join the conversation.

More
11 years 4 months ago #60056 by jtc
Replied by jtc on topic RT-8p8c - An ethernet based interface for LinuxCNC
can you leave your e-mail so I can contact you?

Please Log in to join the conversation.

More
11 years 4 months ago #60057 by kinsa
Replied by kinsa on topic RT-8p8c - An ethernet based interface for LinuxCNC
Send me a mail at
[img

Please Log in to join the conversation.

Time to create page: 0.063 seconds
Powered by Kunena Forum