6i25 + 7i76 hm2/hm2_5i25: unregistered

More
10 years 9 months ago #67850 by bkt
my dmesg.....

Warning: Spoiler!


somethings is wrong ..... I need some driver for starting with my 6i25 card?? These pc is for test and yesterday I have installed an 5i25 fgpa .... I need to make some type of file cleaning??

Regards
Giorgio

Please Log in to join the conversation.

More
10 years 9 months ago #67852 by PCW
The driver and hardware seem OK (card is found and registered)
Looks like maybe a HAL/INI file error

running LinuxCNC from the command line and looking at any error messages there may help

Please Log in to join the conversation.

More
10 years 9 months ago #67858 by cncbasher
post your config as an archive , the driver is loading fine

Please Log in to join the conversation.

More
10 years 9 months ago #67865 by bkt
Sorry at this moment haven't access to .hal file ... but the errors are not recognise 5i25.7i76.0.0.12-in ..... if i comment the line (#) the error compare at successive 5i25......in pin.....

Please Log in to join the conversation.

More
10 years 9 months ago #67866 by PCW
Looks to me like you do not have 7I76 firmware installed on the 5I25/6I25 so no I/O is likely to work

Please Log in to join the conversation.

More
10 years 9 months ago #67867 by bkt
@pcw I suspect something like these..... I install 5i25 firmware or some other??

Tanks
Regards
Giorgio

Please Log in to join the conversation.

More
10 years 9 months ago #67870 by PCW
Yes, use 5i25 firmware , probably 5i25_7i76x2.bit

Please Log in to join the conversation.

More
10 years 9 months ago #67907 by bkt
You are in right .... no 7i76 bitfile in 6i25 board .....When I update her error disappear ...

regards
giorgio

Please Log in to join the conversation.

Time to create page: 0.780 seconds
Powered by Kunena Forum