Need firmware for Chinese BoB on Mesa 7i92

You can sample the probe input in the base thread but motion only looks at it (and latches the position) at the servo thread rate

PCW wrote:

I'll try to get to this sometime this week
 

So, did you create firmware for this setup? I am using this BoB´s in several machines, I would like to switch to driving them by 7i92, but cant find proper pinout in 7i92 firmwares file downloaded from your pages. Or whats the name of file with this pin setup?

______________________________
ParPortPin Function
1 Enable
2 xstep
3 ydir
4 (-I dont need-) SpindlePWMout (creating a 0-5V signal for the VFD with a buffer and low pass filter from this pin)
5 adir
6 astep
7 zstep
8 zdir
9 (-I dont need-)
10 max-home-z
11 min-home-x-and-y
12 (-I dont need-) SpindleSensorIn (RPM sensor, 4 pulse per revolution)
13 probe-in
14 xdir
16 ystep
17 CoolantEnable

Configurations for both the 7I92 and 7I92T plus pinout source:

 

 

Looks it will fit. Thank you so much!