Faldic RYS401S3-VVS and LinuxCNC

More
10 years 1 month ago #79940 by Vladimir
Faldic RYS401S3-VVS and LinuxCNC was created by Vladimir
Hi there!
Can anyone help to run subject with LinuxCNC?
Thanks!
Warning: Spoiler!

Please Log in to join the conversation.

More
10 years 1 month ago #79941 by PCW
Replied by PCW on topic Faldic RYS401S3-VVS and LinuxCNC
That looks like a standard AC servo (400W) that will work with analog or step/dir commands
so will work with General Mechatronics, Mesa Electronics or Pico Systems LinuxCNC drive interfaces

Please Log in to join the conversation.

More
10 years 1 month ago #79988 by andypugh
Replied by andypugh on topic Faldic RYS401S3-VVS and LinuxCNC
Or, I would assume, in step-dir mode from the parallel port, but at limited step rate.

Please Log in to join the conversation.

More
10 years 1 month ago #80000 by Vladimir
Replied by Vladimir on topic Faldic RYS401S3-VVS and LinuxCNC
There is no step/dir support on this driver, only cw/ccw signals, speed control or torque control.

Please Log in to join the conversation.

More
10 years 1 month ago #80001 by andypugh
Replied by andypugh on topic Faldic RYS401S3-VVS and LinuxCNC
If it will work with CW/CCW pulses then that is an option with the parallel port and software step-generator.

[Edit] I am not advocating this over the hardware solutions. Just pointing out the possibility.

Please Log in to join the conversation.

Time to create page: 0.108 seconds
Powered by Kunena Forum