- Posts: 68
- Thank you received: 0
Raspberry Pi and Mesa 7i90 SPI works well
9 years 10 months ago #84909
by tivoi
hi how i can install linuxcnc for RPI3 or where i can find RPI3 image?
thanks you tinkerer
Replied by tivoi on topic Raspberry Pi and Mesa 7i90 SPI works well
tinkerer wrote: Hello fellows,
'will share some pics of my running test setup.
Ok, due to the great demand I will give some additional infos.
SPI cable between raspi3 and 7i90 (max length 20 cm wo differential driver):
Code:Raspi3 40 pin header: 7i90 26 pin header: ===================== =================== 19 - MOSI -------------------------> 13 - SPIIN 21 - MISO <------------------------- 15 - SPIOUT 23 - SCLK -------------------------> 11 - SPICLK 24 - /CS -------------------------> 17 - /SPICS 20 \ 25 - GND <------------------------> 10, 12, 14 - GND 30 /
But not too much, because I'm following the open source tradition, information is a "debt to be collected" ...
Have fun!
m.
hi how i can install linuxcnc for RPI3 or where i can find RPI3 image?
thanks you tinkerer
Please Log in to join the conversation.
Time to create page: 0.067 seconds
