Question about 7I77

More
9 years 10 months ago #84471 by Holzwurm56
Question about 7I77 was created by Holzwurm56
Hello,
I have install a 7I77 for driving my woodcnccenter with servomotors. The 7I77 has 4 screwplugs for field power. Its necessary to connect all 4 screwplugs to 24Volt or is one enough?

Thanks

Hans

Please Log in to join the conversation.

More
9 years 10 months ago #84474 by PCW
Replied by PCW on topic Question about 7I77
One 24V connection is sufficient for most uses (say up to 1A total output load)

if you have the full load on all outputs (~3A) I would use all four

Please Log in to join the conversation.

Time to create page: 0.479 seconds
Powered by Kunena Forum