7i73 questions

More
9 years 5 months ago #93880 by andypugh
Replied by andypugh on topic 7i73 questions

tecno wrote: Any thoughts about having the limits/home switches NO as I would like to take out the relay-board
this just for clean install that is easy to get a overall view of.


How hard would it be to change the switches?

Though the OEM thought that NO was OK, and presumably knew what they were doing.

Please Log in to join the conversation.

More
9 years 5 months ago #93881 by tecno
Replied by tecno on topic 7i73 questions
Not possible to get physically to do this, way too much heavy metal to be removed. The Z knee and X axis table.

Below schematics for the NO/NC conversion via relay-board

Attachment not found

Please Log in to join the conversation.

More
9 years 5 months ago #93882 by andypugh
Replied by andypugh on topic 7i73 questions
I can't help feeling that the conversion relay board adds more possible failure modes than just keeping the NO switches.

Please Log in to join the conversation.

More
9 years 5 months ago #93883 by tecno
Replied by tecno on topic 7i73 questions
I agree even if NO is a bit backwards.

Please Log in to join the conversation.

More
9 years 4 months ago #94254 by tecno
Replied by tecno on topic 7i73 questions
Been away for a few days on short holiday.

Have made up following list for connecting I/O to 7i73 in the controlbox.

Attachment not found



Attachment not found


Attachment not found




Is this somewhat correctly connected?
Want to use 24VDC on Limit/Home swithes and convert these signals to 3.3VDC

My order is now shipped from Mesa and hopefully here by the end of next week.

Please Log in to join the conversation.

More
9 years 4 months ago #94259 by andypugh
Replied by andypugh on topic 7i73 questions

tecno wrote: Want to use 24VDC on Limit/Home swithes and convert these signals to 3.3VDC


It might be easier to use an opto-isolator.

Something like se.rs-online.com/web/p/optocouplers/4530909/

But I would suggest seeing if PCW can suggest an optimal output-type for it.

Please Log in to join the conversation.

More
9 years 4 months ago #94262 by tecno
Replied by tecno on topic 7i73 questions

Attachment not found



I have made these to my former Kflop/Kanalog setup so I can use these.

Please Log in to join the conversation.

More
9 years 4 months ago #94341 by tecno
Replied by tecno on topic 7i73 questions
PCW

Any hint on how to sink higher loads on these outputs that only can sink 4mA?

Transistor or FET's?


I have some BSP125 Logic FET´s, I assume these would do the job?
Only load would be signal lamps.

Please Log in to join the conversation.

More
9 years 4 months ago #94352 by PCW
Replied by PCW on topic 7i73 questions
FETs or Optos should work fine

Please Log in to join the conversation.

More
9 years 4 months ago #94425 by andypugh
Replied by andypugh on topic 7i73 questions
Sounds like a good use for the ULN.... chips too.
se.rs-online.com/web/p/darlington-transistors/7141167/
Handy 8-channel package for logic-level to 50V / 0.5A

Please Log in to join the conversation.

Time to create page: 0.056 seconds
Powered by Kunena Forum