2 X axis motors on a 7i76

Hi all

I have recently installed my 7i76 and have my Y and Z motors working but can't get my X motors to respond. I have 2 on a gantry, this was easy with parallel port by specifying that X was on 2 different sets of pins. With the 7i76 being alot different I haven't yet been able to work out how to get both motors to be assigned to X axis but on different pins.

Anyone have any pointers?

Cheers

SEEK and you shall find:
www.forum.linuxcnc.org/39-pncconf/28828-...er-motors-for-x-axis

And it works......both with the new setting and wiring the step & dir wires correctly