Break-out-board compatibility

Aziris
Topic Author
Offline
New Member

9 years 1 week ago #100558 by Aziris

Break-out-board compatibility was created by Aziris

Hi guys,

If I am running Mach3 over Parallel Port to my Chineese BOB with success, is there any chance LinuxCNC would require a different BOB?

BR,
Maris

Please Log in to join the conversation.

PCW
Offline
Platinum Member

9 years 1 week ago #100559 by PCW

Replied by PCW on topic Break-out-board compatibility

Almost any Mach compatible parallel port BOB should work with LinuxCNC

Also LinuxCNCs parallel port configuration tool ( stepconf ) can read Mach xml files to
minimize the work needed to change to LinuxCNC

Please Log in to join the conversation.

Time to create page: 3.259 seconds