reflash 7i76 connected with 7i92 possible?

I need to upgrade the firmware on the 7i76.
I'm using a 7i92, which doesn't seem to work to flash the sserial
it doesn't see the 7i76 when hostmot2 is loaded with setup speed baud.

First - is this possible I can't see any reference to using cards other then the 5i25. 6i25...

If it should work, then i'll give more detail to what I have done so far...

Thanks
Chris M

I don't think I've tried this particular combination but it certainly should work

something like ./updatess-eth 7i76 7i92 0

Note that the updatess-eth script assumes a 10.10.10.10 Ethernet FPGA card IP address

Yes I got it to work thanks.
I suspect I didn't get the jumper set correctly the first time.

One thing is the readme mentions using commands such as:
./updateess .....

That looks like a bash command yet the update files are HAL files.
I did it by hand in a halrun environment.

Maybe I missed something there but anyways thanks it helps when you know it is supposed to work

Chris M

Actually that's a bash file that creates a hal file from a template and then runs it with halrun

You may not have power cycled after moving the jumper (the bash file reminds you to do this)

cmorley wrote: That looks like a bash command yet the update files are HAL files.
I did it by hand in a halrun environment.

There are bash scripts if you get the driver update file from Mesa.

I probably should change the setsserial manpage to reflect that.