Linux CNC and smoothieboard

More
8 years 1 month ago #117357 by maxencer
Linux CNC and smoothieboard was created by maxencer
Hi,
I try to connect a smoothieboard at Linuxcnc with usb, is possible ?

thx

Please Log in to join the conversation.

More
8 years 1 month ago #117360 by Todd Zuercher
Replied by Todd Zuercher on topic Linux CNC and smoothieboard
No

Please Log in to join the conversation.

More
8 years 1 month ago #117361 by tommylight
Replied by tommylight on topic Linux CNC and smoothieboard
No, as far as i am aware.
Linuxcnc can control USB pendants and with an 485 converter the VFD, but it can not control a machine over USB due to inherent lag in the USB communication.
Also the smoothieboard is a software and hardware controller, Linuxcnc is a software controller that can control different types of hardware.

Please Log in to join the conversation.

More
5 years 6 months ago #205999 by tjtr33
Replied by tjtr33 on topic Linux CNC and smoothieboard
Hello, things change ( rule # 128a.5 )
look at
remora-docs.readthedocs.io/en/latest/
an linuxcnc spi smoothieboard driver
I'm still reading ...
tomp

Please Log in to join the conversation.

Time to create page: 0.102 seconds
Powered by Kunena Forum