xhc-mk4 controller

8 years 1 month ago #117504 by Wibart

xhc-mk4 controller was created by Wibart

Hello member,
is it possible to use xhc-mk4 USB board with linuxCNC? It was designed for Mach3.

Please Log in to join the conversation.

8 years 1 month ago #117529 by Todd Zuercher

Replied by Todd Zuercher on topic xhc-mk4 controller

I think so. I believe someone made a driver (hal component) for it.
wiki.linuxcnc.org/cgi-bin/wiki.pl?Using_...Wireless_MPG_Pendant

Please Log in to join the conversation.

Time to create page: 0.129 seconds