Bob Campbell break out board with linux?

More
7 years 11 months ago #119779 by i_r_machinist
Bob Campbell break out board with linux? was created by i_r_machinist
Hello,
Back in 2010 I retrofitted a 4 axis milling machine with Mach3, a Bob Campbell BOB, and viper 200 drives. I'm tired of fighting Windows. My question is, does anyone have experience running Linux with a Bob Campbell break out board? Can it be done?
Thanks
i_r_machinist

Please Log in to join the conversation.

More
7 years 11 months ago #119783 by tommylight
Replied by tommylight on topic Bob Campbell break out board with linux?
Both of them should work, just be sure to enable charge pump on pin 1 i think, if they use parallel port.

Please Log in to join the conversation.

Time to create page: 0.808 seconds
Powered by Kunena Forum