Disabling or bypassing the enable function on a DM542T

Hi all

I have a Leadshine MX3660 driving a 4th axis via it's outputs though it uses three of the four available step, dir and enable. I'm just wondering whether I can bypass the enable or fool it in some way so I can free up the 3rd output to give me five axis milling?

Cheers

Jools

simply do not connect any Plug of the ENA
eighter ena+ or ena-
then the stepper is always on

BUT keep in ind this may kill the Driver as there is full AMP at the power on to all Stepeprs
BETTER to use a relay and a outpin to controll this by MASHINE on signal
NOT e-stop