Spindle pins Mesa 7i76e + power source

So, i did this before, but to make this more clear i have this question.

With my new servo spindle motor drive i got verious pins to use.
Two of them are for 0-10v analog controll. The pins called AS+ and AS-.

As far my knowledge goes, i assume that the driver does not 'give' 10v

Question
Is true that the Spindle+ Spindle OUT and Spindle- are a opencollector?

If so, that meens that i have to add 10V tot the Spindle+ from a external power source?

While im here, is it true if i connect my 24v on TB1 and on the TB3 Pin 23 and 22, that i don't need a external 5v power source?

hi
yes and yes
A: only 24V no 5V needed
B you need the external 10V
i added 2 images

Thanks!

So where do i leave the ground from the 10v power source? on Pin 1 where also AS- from the servo driver goes to?

STOP
The drawing is wrong!

There must not be a connection between annalog 10V pin the digital pins. This drawing is not actually.
Mike

Mike_Eitel wrote: STOP
The drawing is wrong!

There must not be a connection between annalog 10V pin the digital pins. This drawing is not actually.
Mike

Now I see that it's a different version then I have. Dir+ and Enable+ should be connected to a 12 or 24v power source right?

Yes
Hope you have not jet grilled anything

Mike_Eitel wrote: Yes
Hope you have not jet grilled anything

Haha, no.
I never saw that other version of the drawing. I would give me doubts though.

I will share my type of wiring with coding soon.

Mike_Eitel wrote: Yes
Hope you have not jet grilled anything

BBQ !!!

Yes Tommy, bbq
And in both variants with beer,
either to forget your frustration or to celebrate that you had good luck.
Mike