7i92 pwm inverted

is there a pin to invert the pwm signal on the 7i92 with a China Bob configuration

On Linuxcnc 2.7 and earlier you set the invert_output attribute of the GPIO pin
the PWM output uses:

setp hm2_7i92.0.gpio.XXX.invert_output true

on LinuxCNC 2.8 and later there is an alias that makes this easier:

setp hm2_7i92.0.pwmgen.00.out0.invert_output true

thank you dident find that in the documentation

2.9 master on System

pl7i92 wrote: thank you dident find that in the documentation

2.9 master on System

Because its got nothing to do with Linuxcnc as it hardware specific

rodw wrote: Because its got nothing to do with Linuxcnc as it hardware specific

It could go in this (badly formatted) manpage:
linuxcnc.org/docs/2.8/html/man/man9/hostmot2.9.html#pwmgen