Hello,
I got a ROD 426 that I want to hook to the 7i76 spindle encoder pins.
I read many posts on the forum and went through the Heidenhain Rotary_Encoders_en.pdf and the Interfaces_en.pdf (relevant pages in the attached pdf).
This encoder is TTL and provides differential outputs. So far so good.
In page 6 of the pdf, there is a section and a diagram.
It shows :
"Input circuit of the subsequent electronics
Dimensioning
IC1 = Recommended differential line receiver:
DS 26 C 32 AT Only for a > 0.1 μs: AM 26 LS 32
MC 3486
SN 75 ALS 193"
Is the 7i76 encoder IC compatible with a recommended one so that I can wired them straight ?
Thanks for help.
