Bitsensor controller

More
6 years 7 months ago #160020 by ionapostol@gmail.com
Bitsensor controller was created by ionapostol@gmail.com
Hi,
I have this controller board bitsensor card
Will work with Linuxcnc ?
Thanks

Please Log in to join the conversation.

More
6 years 7 months ago #160038 by andypugh
Replied by andypugh on topic Bitsensor controller
Sorry, No. That's basically a complete motion controller that uses (a very small part of) Mach3 as the GUI.

On the plus side, there is no way that LinuxCNC could ever run that controller better than Mach does, so you are not losing out.

Please Log in to join the conversation.

More
6 years 7 months ago #160046 by ionapostol@gmail.com
Replied by ionapostol@gmail.com on topic Bitsensor controller
Ok, thank you. I was thinking that I can use linux not windows which need licence.

Please Log in to join the conversation.

More
6 years 7 months ago #160047 by andypugh
Replied by andypugh on topic Bitsensor controller
It _might_ work with Universal G-code sender:

winder.github.io/ugs_website/

Please Log in to join the conversation.

Time to create page: 0.085 seconds
Powered by Kunena Forum