Power supply selection for stepper based config

More
6 years 6 months ago #164157 by alkabal
Replied by alkabal on topic Power supply selection for stepper based config
For the moment i can't found with only one output, but is possible to connect in //

Please Log in to join the conversation.

More
6 years 6 months ago #164158 by alkabal
Replied by alkabal on topic Power supply selection for stepper based config
Today searching a box for all the electronic a friend gift me a ski pass box

With some material inside
a SMPS 12v MEANWELL :laugh:
a mini computer VDX-6326D with 2Gb compact flash
a strange modul that seem to be a 12v to 3x12v + 5v converter + manage 3 LED and have RS232 connection

Funny

Please Log in to join the conversation.

More
6 years 6 months ago #164159 by tommylight
Replied by tommylight on topic Power supply selection for stepper based config
If it has 4 wires on the output, you can use that. They just have to be set in parallel.
Nice box, with lights and all ! :)

Please Log in to join the conversation.

More
6 years 6 months ago #164162 by alkabal
Replied by alkabal on topic Power supply selection for stepper based config
Yes both datasheet says 4 wire output
I hope this is good option and the price is correct.

Many thanks for all answear

Ps : Mouser 103 euro shipping VS Radiospare free shipping :blink:

Please Log in to join the conversation.

More
6 years 6 months ago #164175 by tommylight
Replied by tommylight on topic Power supply selection for stepper based config

alkabal wrote:
Ps : Mouser 103 euro shipping VS Radiospare free shipping :blink:

Missed that !

Please Log in to join the conversation.

More
6 years 6 months ago #164210 by alkabal
Replied by alkabal on topic Power supply selection for stepper based config
No eBay APP ID and/or Cert ID defined in Kunena configurationAt the end i found this one

Please Log in to join the conversation.

More
6 years 6 months ago #164240 by Clive S
Replied by Clive S on topic Power supply selection for stepper based config
No eBay APP ID and/or Cert ID defined in Kunena configuration

alkabal wrote: At the end i found this one


1000Va is overkill and will give you problems with inrush current 625Va would be more than enough in my opinion.

Please Log in to join the conversation.

More
6 years 6 months ago #164257 by tommylight
Replied by tommylight on topic Power supply selection for stepper based config
That should do just fine.
And the 1000VA is under 900W, depending on the power factor.

Please Log in to join the conversation.

More
6 years 6 months ago #164373 by alkabal
Replied by alkabal on topic Power supply selection for stepper based config
Order done, many thanks

Please Log in to join the conversation.

Time to create page: 0.099 seconds
Powered by Kunena Forum