Mesa 7i96, which pin for PWM?

I've changed firmware to the 4 axis + 1 pwm on my 7i96. Which pin on the board will be the PWM output? I suppose it has to be one of the pins for the 5:th axis.

Thanks in advance.

Stepgen 4 Step/Dir are replaced with PWMgen 0 PWM/Dir

Thanks, I didn't think of "dir", hence my question for just one pin. My motor controller only has an input pin for "spindle PWM", which in turn makes the controller outputting 0-10V to the VFD.

I'm guessing that no there is no dir pin because the spindle is not reversible via this controller.

This concludes my connection of the 7i96. Next step will be to configure LCNC.