Mesa 7i76 - setting nvencmode0 to 4 - how?

I also have a 7i76e and a mate who is on 7i76e has expressed an interest in applying the firmware as well.

I didn’t see anything in the read me on applying to the Ethernet board. Are there instructions I can follow for that board?

Cheers,
J.

You would use updatess-eth

You may need to edit updategeneric-eth.hal
to change the IP address

cool - that sounds easy, And assume do any jumper changes on the board as needed per its instruciton manual to enter a setup mode v's operate mode.

And for the record, really appreciate your help and responses.

Cheers,
James.

formware loaded into 6i25/7i76 and working from what I can see.