Mesa P1 Connector Type 7i92m

Hi,

Is the listed HDR 26 connector P1 on Mesa 7i92m the same as a IDC 26 connector? I just realized that all my ribbon cables are too wide!
Any suggestions on a clean assembly? Just need to break out a couple of wires to a spinx off that P1. Does anyone make a DB25/IDC 26 stubby that could socket into that HDR 26 connector? Or crimp/solder terminal? I'd like to avoid a long ribbon cable.

Thanks

You can also use arduino cables with those small female connectors :
www.google.com/search?q=arduino+jumper+w...imgrc=mUdlWS7BwhARzM
They do work nicely, i have 4 or 5 of them on a 7i92.

No eBay APP ID and/or Cert ID defined in Kunena configuration

OT-CNC wrote: Hi,

Is the listed HDR 26 connector P1 on Mesa 7i92m the same as a IDC 26 connector? I just realized that all my ribbon cables are too wide!
Any suggestions on a clean assembly? Just need to break out a couple of wires to a spinx off that P1. Does anyone make a DB25/IDC 26 stubby that could socket into that HDR 26 connector? Or crimp/solder terminal? I'd like to avoid a long ribbon cable.

Thanks

like these

Thanks guys. I ended up settling on a din BOB.