7i92h with 7i77, 7i74,7i71,7i70,7i73

More
6 years 3 weeks ago #184835 by PCW
That's the parameter name but what's the value?

Please Log in to join the conversation.

More
6 years 3 weeks ago #184907 by Thods1222
Owner:28, type: u32, Dir:R0, value:0x00000003

Please Log in to join the conversation.

More
6 years 3 weeks ago #184910 by PCW
Can you start LinuxCNC and run this command in a terminal:

halcmd show all > all.txt

and post all.txt here?

Please Log in to join the conversation.

More
6 years 3 weeks ago #184918 by Thods1222
Here is the output of the all.txt.

Attachment not found

Please Log in to join the conversation.

More
6 years 3 weeks ago #184920 by PCW
Ack, I didn't think there were any with that firmware revision released.
It should be possible to update the firmware in place. The sserial.tg
file has all the required files but I'm not sure if the scripts will work
with sserial port 1. I will take a look tomorrow.

freeby.mesanet.com/software/parallel/sserial.tgz

Please Log in to join the conversation.

More
6 years 3 weeks ago #185121 by Thods1222
I wonder if it would be easier to do an RMA and cycle this back for the firmware update since it seems I have a problematic card.

Please Log in to join the conversation.

More
6 years 3 weeks ago #185125 by PCW
Probably, there's something odd about a 03 revision as I don't think any cards with rev. 03 firmware actually shipped.

If you email Mesa with a RMA request I will issue a RMA #

Please Log in to join the conversation.

More
6 years 2 weeks ago #185713 by Thods1222
Ok, I shipped it back. It should be to you on Tuesday. Thanks for your help.

Please Log in to join the conversation.

More
6 years 2 weeks ago #186041 by PCW
OK, fixed.

It is a really old card (8-9 years?) so the 03 version was probably legitimate
but probably best updated here as its so old the remote firmware
update method might have failed.

Please Log in to join the conversation.

More
6 years 2 weeks ago #186046 by Thods1222
It looks like we made the right call by sending it back for the update. Thanks for your help.

Please Log in to join the conversation.

Time to create page: 0.090 seconds
Powered by Kunena Forum