Where to begin with 7I76E card?

More
5 years 11 months ago #188691 by txtrone
Where to begin with 7I76E card? was created by txtrone
I have the 7I76E powered up and connected to my LinuxCNC computer. I have two NICs and did a ping test with each, chose the fastest. What is the next logical step? My intended use is a 4 axis plasma table.

Do I need to connect to the card in the Plasmac? Or upgrade firmware first?

Please Log in to join the conversation.

More
5 years 11 months ago #188694 by tommylight
Replied by tommylight on topic Where to begin with 7I76E card?
forum.linuxcnc.org/plasmac/37234-plasmac-documentation
No need to upgrade firmware, i think.

Please Log in to join the conversation.

More
5 years 11 months ago #188697 by txtrone
Replied by txtrone on topic Where to begin with 7I76E card?
Ok, I know I have seen some wiring diagrams on here for this Mesa card. I will look around some.

Please Log in to join the conversation.

More
5 years 11 months ago #188699 by JohnnyCNC
Replied by JohnnyCNC on topic Where to begin with 7I76E card?
This one?

forum.linuxcnc.org/media/kunena/attachme...hluss_2017-01-02.pdf

Please Log in to join the conversation.

More
5 years 11 months ago #188704 by txtrone
Replied by txtrone on topic Where to begin with 7I76E card?
Thanks! That's the one!

Please Log in to join the conversation.

Time to create page: 0.083 seconds
Powered by Kunena Forum