Mesa 7I76e - Two power supplies or one?

txtrone wrote: Thanks! I flipped the switch and no smoke!

You lucky ....

tommylight wrote:

txtrone wrote: Thanks! I flipped the switch and no smoke!

You lucky ....

Well, I have the 7I76E powered up, set to 10.10.10.10, followed your instructions on setting up network manager to allow for internet on separate nic... what is the logical next step? Setting up stepper drives?

txtrone wrote:

tommylight wrote:

txtrone wrote: Thanks! I flipped the switch and no smoke!

You lucky ....

Well, I have the 7I76E powered up, set to 10.10.10.10, followed your instructions on setting up network manager to allow for internet on separate nic... what is the logical next step? Setting up stepper drives?

Yup, pretty much there is nothing more there, well besides the closed loop spindle/VFD connection if you intend to use one.

Thanks! I will try adding some tonight after work. I plan to run 4 stepper motors for a plasma table, 4 home switches, an ohmic sensor at some point, and then the 8 outputs for the downdraft vent system that rodw is helping me with. The ohmic sensor can wait, I just want to get the table moving with this system for now.