INI conf for USC Pico Systems in MM

Hi, I'm looking for an INI config to base on for my configuration in milimeters, last year I'm use the INI file inclueded in Linuxcnc 2.7 and works fine, but I always worked in metric system and I'll like to work in mm. I intended to adpat the file that I probed last year to my needs, but dont get it work.

thanks in advance.

Moved to "driver boards" category.

There's really nothing special about a mm config. In the [TRAJ] section of the .ini file,
you set LINEAR_UNITS=mm, and re-scale velocities and step scales accordingly.
That's about all you need to do.

Jon