7i95 installing

I once needed help installing a Mesa 7i95.
I don't know anything about Linux at all.
I managed to install Linuxcnc 2.9 master after reading a lot.
I am using Linuxcnc PNCconf Wizard to configure the Mesa Card.
By the "Discovery Option" i read the Mesa 7i95 Data from Card? Is this corect?
If starting Linuxcnc i get an error for watchdog 7i96?
Please take a look at the error.
Thank you in advance for your effort

Greatings Achim

Error ?

parameter or pin ´hm2_7i96.0.watchdog.timeout_ns´ not found

You would need to replace all instances of "7i96" with "7i95" in the hal/ini files

i take a look in the (mesa_7i95.hal)
in Line
15 addf hm2_7i96.0.read servo-thread
i must chage it in
15 addf hm2_7i95.0.read servo-thread
is this the right way to do?

Well, I would do it globally with the editor.

In the text editor, "search and replace" or CTRL+H

o.k.
i do that and i can start linuxcnc.
Thank you . That was easy .

the LED Documentation from the the 7i95 is ???.
My LED green
CR 1 off
CR 2 on
CR 3 on
CR 4 on
CR 19 on (Red) (INIT)
CR 20 ? ( off) Done
CR 21 On ( Yellow) PWR
The documentation writes something from CR11 and CR12 ????

The text in the manual is wrong (the table is correct)
CR11 should be CR19
CR12 should be CR20