Mesa 7i76e Plasma bit file

5 years 6 months ago #206829 by txtrone

Replied by txtrone on topic Mesa 7i76e Plasma bit file

PCW wrote: I would set num_encoders=2 and use the "B" encoder input (encoder 01)
for the Ohmic sensing

Done. Here is the new error. Attached are my machine and connection hal files.

Code:

twopass: Error in file ./mark_i_connections.hal:
    unlink failed
HAL: ERROR: pin 'debounce.0.1.in' not found
15153

Please Log in to join the conversation.

5 years 6 months ago #206832 by PCW

Replied by PCW on topic Mesa 7i76e Plasma bit file

The "dbounce" component is loaded but a "debounce" pin is referenced

Please Log in to join the conversation.

5 years 6 months ago #206836 by rodw

Replied by rodw on topic Mesa 7i76e Plasma bit file

Sorry. if it was based on an example of mine, I blew up the Encoder A/0 a long time ago so have been using encoder 1 & 2 forever

Please Log in to join the conversation.

5 years 6 months ago #206837 by txtrone

Replied by txtrone on topic Mesa 7i76e Plasma bit file

rodw wrote: Sorry. if it was based on an example of mine, I blew up the Encoder A/0 a long time ago so have been using encoder 1 & 2 forever

heh ... Spaceship emergency landing?

Please Log in to join the conversation.

5 years 6 months ago #206839 by txtrone

Replied by txtrone on topic Mesa 7i76e Plasma bit file

PCW wrote: The "dbounce" component is loaded but a "debounce" pin is referenced

Yes, I missed this part at the bottom of the error report.

Code:

HAL: ERROR: pin 'debounce.0.1.in' not found
15153

Please Log in to join the conversation.

Time to create page: 0.155 seconds