Using 7i96 to Switch 110V Relay for Palm Router

Thanks for taking a look, this is what i assume should trigger output zero when i send a code for spindle on.

# --- SPINDLE-ENABLE ---
net spindle-enable => hm2_7i96.0.ssr.00.out-00

The signal spindle-enable is not connected to any source in your hal file

You would to add need something like:

net spindle-enable <= spindle.0.on

Would that also go under
# --- SPINDLE-ENABLE --- ?

I didn't see any other options in stepping through PNCCONF to add any additional spindle enable sources.

Was able to run out to the shop. That did it, Thank you so much for the help.

Might be a bug in pncconf when setting up really minimal spindle control
with just a on/off output