- Posts: 913
- Thank you received: 0
7i96 Configuration Tool Deb
- robertspark
- Topic Author
- Offline
- Platinum Member
-
5 years 9 months ago #197161
by robertspark
nice tool!:woohoo:
what about step + dir spindle (I use a servo on my lathe)
do I just set it up as an axis on the general tab and the encoder input as a spindle as per pncconf
7i96 Configuration Tool Deb was created by robertspark
BigJohnT wrote: On the spindle tab you can configure all 4 types of PWM spindle types.
JT
nice tool!:woohoo:
what about step + dir spindle (I use a servo on my lathe)
do I just set it up as an axis on the general tab and the encoder input as a spindle as per pncconf
Please Log in to join the conversation.
Time to create page: 0.139 seconds