configuracion mesa 6i24 en pncconf

Buenos dias, mi Nombre es Eric Crinigan. Estoy arrancando un proyecto con Linuxcnc y soy nuevo en el tema. compre una placa mesa 6I24 y una 7i33. para manejar 4 ejes con servomotor realimentado.
mi consulta es como configurar la placa 6i24 con pncconf ya que no aparece entre las opciones disponibles de firmware.
Gracias

Moved to "driver boards" section of the forum.
Translated via google:
Good morning, my name is Eric Crinigan. I am starting a project with Linuxcnc and I am new to the subject. buy a 6I24 and a 7i33 tabletop. to drive 4 axes with feedback servo motor.
my query is how to configure the 6i24 board with pncconf as it is not listed among the available firmware options.
Thanks

The 6i24 is the CPIe version of the 5i24. It uses the same firmware.

In fact a 6i24 will even be referred to as a 5i24 in HAL.

So select "5i24" and everything should work perfectly.

I wish that this was more obvious.