LinuxCNC using ESP32 as Stepper Generator.

More
5 years 7 months ago #203047 by kwarup
LinuxCNC using ESP32 as Stepper Generator. was created by kwarup
So I found on GitHub (Cleverson Deotti) a example of using one ESP32 to drive motor stepper
I' ve cloned and added some things.

github.com/dlhenke/linuxcnc-esp32

Please Log in to join the conversation.

More
5 years 7 months ago #203094 by Aciera
Replied by Aciera on topic LinuxCNC using ESP32 as Stepper Generator.

If some of you could help..


So what is it you would like help with?

Please Log in to join the conversation.

More
5 years 7 months ago #203109 by kwarup
Replied by kwarup on topic LinuxCNC using ESP32 as Stepper Generator.
Drive this project forward if possible.

Please Log in to join the conversation.

More
5 years 5 months ago #210628 by tjtr33
Replied by tjtr33 on topic LinuxCNC using ESP32 as Stepper Generator.
Hi,
most of this conversation is on' another topic
please look at topic named
linuxcnc-esp32 Software Stepping over Ethernet Using ESP32

thanks for your github, i used the configs to try to make it work

tomp tjtr33

Please Log in to join the conversation.

More
1 year 7 months ago #324300 by leandrocontarini
Replied by leandrocontarini on topic LinuxCNC using ESP32 as Stepper Generator.
Hello, how are you?
Did you save these files?
I saw that you deleted the link.

Please Log in to join the conversation.

More
1 year 7 months ago #324302 by leandrocontarini
Replied by leandrocontarini on topic LinuxCNC using ESP32 as Stepper Generator.
Hello, could you share these files?
The link has been deleted

Please Log in to join the conversation.

Time to create page: 0.223 seconds
Powered by Kunena Forum