7i95 Configuration Tool

More
5 years 6 months ago #207341 by BigJohnT
7i95 Configuration Tool was created by BigJohnT
I just pushed the start of the 7i95 Configuration Tool. It should make a basic configuration. If anyone has a 7i95 ( I'm out of stock ) can you check the configuration with your card?

JT

Please Log in to join the conversation.

More
5 years 6 months ago #207369 by BigJohnT
Replied by BigJohnT on topic 7i95 Configuration Tool
I just pushed more content to the 7i95 Configuration tool and it should now make a working configuration. Only a few things to finish adding tomorrow...

JT

Please Log in to join the conversation.

  • aventtini
  • New Member
  • New Member
More
5 years 6 months ago #207430 by aventtini
Replied by aventtini on topic 7i95 Configuration Tool
That good. I just started a 5 axis machine with 7i95 . În currios if it works with SSI encoder direct. Next week I Will try to finish the panel , siemens dc motors 4kw , SSI encoders, or incremental 8000ppr . Drivers are step dir dc , 7i95 . Travel îs 3x2m . I Will make a post about it next week

Please Log in to join the conversation.

More
5 years 6 months ago #207496 by BigJohnT
Replied by BigJohnT on topic 7i95 Configuration Tool
I keep adding to the 7i95 Configuration Tool so feedback is crucial for me to make sure everything is working as expected with the Configuration Tool.

You might want to start a new thread asking about the SSI encoders... I don't even know what one is.

JT

Please Log in to join the conversation.

Time to create page: 0.092 seconds
Powered by Kunena Forum