fieldbus systems

More
5 years 5 months ago #209265 by vre
fieldbus systems was created by vre
Hello
Linuxcnc supports fieldbus systems like devicenet/interbus/profibus/canopen/ethercat ?
For example to use i/o modules from wago/beckhoff ?

Please Log in to join the conversation.

More
5 years 5 months ago #209267 by aleksamc
Replied by aleksamc on topic fieldbus systems
As I know linuxcnc can use ethercat. Some info here

Please Log in to join the conversation.

More
5 years 5 months ago #209352 by Roiki
Replied by Roiki on topic fieldbus systems
Ethercat only since none of them have easily accessible master systems for people to work on. They always cost an arm and a leg.

Please Log in to join the conversation.

More
5 years 5 months ago #209474 by vre
Replied by vre on topic fieldbus systems
ethercat does not needs special hardware on master (pc side)?
Ethernet port is enough ?
Seems good option...

Please Log in to join the conversation.

More
5 years 5 months ago #209659 by Roiki
Replied by Roiki on topic fieldbus systems
It needs a realtime Kernel, a software stack and compatible Ethernet drivers. You can either do this in a separate card with a dedicated processor and API or entirely in software like linuxcnc does.

Please Log in to join the conversation.

Time to create page: 0.084 seconds
Powered by Kunena Forum