7i76e start up error

oh, I switch to "performance"

cpupower frequency-set --governor performance

papa@linuxcnc:~$ halcmd show param *.tmax
Parameters:
Owner Type Dir Value Name
26 s32 RW 0 hm2_7i76e.0.read-request.tmax
26 s32 RW 479298 hm2_7i76e.0.read.tmax
26 s32 RW 65046 hm2_7i76e.0.write.tmax
19 s32 RW 5180 motion-command-handler.tmax
19 s32 RW 41958 motion-controller.tmax
29 s32 RW 2294 pid.s.do-pid-calcs.tmax
29 s32 RW 4884 pid.x.do-pid-calcs.tmax
29 s32 RW 2590 pid.x2.do-pid-calcs.tmax
29 s32 RW 2368 pid.y.do-pid-calcs.tmax
29 s32 RW 2368 pid.z.do-pid-calcs.tmax
20 s32 RW 583231 servo-thread.tmax

Change the 5V power supply ???

I have 24v powered in, as described in that one PDF.

TB1 field power pin 8 GND, pin 5 +24V
TB3 power pin 23 : GND and pin 22 _24 V

is this good, now ?

20 s32 RW 583231 servo-thread.tmax

Should be fine for a 1 KHz servo thread